Ignition Interlock Device
The only way to deter DUI offenders is with the installation of an Ignition Interlock Device (IID).
However, automobile technology has changed, more vehicles are incorporating start/stop technology to reduce emissions and increase gas mileage.
On older vehicles the IID works fine, but over the past several years vehicles with start/stop technology are becoming the norm,
with predicitions of 70% of the cars on the road incorporating such a feature by 2020.
Many states are passing laws that require first time offenders to install an IID in their vehicle.
However, vehicles that are equipped with start/stop technology are being turned away by IID installers because
they don't have a solution to the problem that occurs when an IID is installed on a vehicle with start/stop technology.
The problem occurs when an IID performs a rolling retest, that is when the operator of the vehicle is requested to give a breathe sample
after the vehicle has been running a certain length of time. If the vehicle happens to be stopped or comes to a stop after the request has been given,
the vehicle engine will not restart until a valid BAC retest has been completed. This could temporarily place the vehicle and its occupants
in an unsafe situation, such as in the middle of an intersection, in a construction zone, or on the side of a mountain.
By implementing our patent pending logic circuit with the IID, we eliminate the problem, and the operation of the IID is not modified.
Safety is not compromised; the IID and LC will be installed as a deterent, reducing the liability for the IID manufacturer.
Contact Pioneer Cable Company to find out more about our technology and licensing.
Cables, PC Boards, Sub Assemblies, Finished Product
Electronics - Board Assembly, Printed Circuit, Surface Mount
Automated Insertion for through-hole and Automated Placement for Surface Mount applications
Solder Wave, Flow Solder,
Wiring Harnesses, Cable Assemblies
Assembly, Subassemblies or complete products
we can build the boards, source and place the components and then solder them.
From thru-hole to surface mount parts, we’re ready to build it for you.
Whether your product requires cabling, harnesses, subassemblies or interconnects,
we have the automated equipment and experience to get the job done right and on time.
Contact us to discuss your specific needs.
